Do you know how to read a tape measure? If not, or are in doubt, let us show you how.
A tape measure is a tool designed to take the dimension of an object or area. Tape measures are available in various sizes and lengths ranging from smaller sizes of three feet or below to more than one hundred feet in length.
Despite the length of the measuring tape used, you will usually find them in two types which are metric or imperial.
How To Read A Tape Measure
The decision is yours to make for either though, no doubt, the selection will be influenced by what you measure or the country where you reside in.
Area or surface to be measured
Using a measuring tape simply requires that you pull the tape and measure what you want and let it go for itself- retracting or back up physically depending on the variety you use.
If there is a tape measure that is imperial or metric, there is no difficulty reading the primes, but there may be some readings troublesome between the slots used for the measurements between the numbered steps.
To distinguish between the two, Imperial is calculated in feet and inches while metric is measured in millimeters and centimeters.
Reading a tape measure in Imperial:
Tape measures in imperial units are in the order of an inch to the greater length of the strip with notches between each number representing a sixteenth of an inch.
An easy technique to play the slots is to consider measures sixteen at any time and then divide the number by two.
So count the notches at the beginning , we have zero, one- sixteenth of an inch , then two-sixteenth and so on until you get sixteen-sixteenth, you either continually halved until you have one left. Or divide by sixteen top down, because they are multiples of two.
Therefore reading all zero notches one inch you’d have 1/16, 1/8, 3/16, 1/4, 5/16, 3/8, 7/16, 1/2, 9/16, 5/8, 11/16, 3/4, 13/16, 7/8, 15/16, and 12 inches 1.
All you ride on a tape measure imperial you will likely see the amount of feet, including the amount of inches you measured. Because it was generally regulated, but might not be there in all brands.
How to read a measuring tape in Metric:
The metric tape measure is a little easier to read than the imperial, since the metric system is designed to have all the numbers divisible by 10.
A distinction would be that the imperial uses inches and an inch segments and feet; inch sections are divided into sixteen and twelve inches make a foot.
With 10 metric millimeters is equivalent to one centimeter and 100 centimeters to one meter; all numbers are divisible by 10 and notches on a metric tape measure between 0 and 10 rather than 16.
This means that you can simply look for the measurement between zero and one centimeter by totaling 0.1, 0.2, and 0.3, etc. until 0.9 and 1.0 centimeters, finally.
Any number thereafter was 1.1, 1.2 etc. until 2.0 centimeters, and the movement would continue along the total length thereof.
The imperial and metric rules are totally different, and although in some cases you may be able to convert between the two, it is strongly discouraged.
Individuals in the field of auto mechanics can tell you that you may be able to find an imperial measurement corresponding to a metric and vice versa.
But they will also inform you that the tools may not exactly match since the two different standards are combined.
For best results, you should keep in a standard and follow a guide in a book or online using the recommended measures and standard.